The thicknesses of TaO x and TiO x N y layers are approximately 7 and 3 nm, respectively. This is due to the fact

that Ti is more reactive with O2 (Gibb’s free energy −883.32 kJ/mol at 300 K [19, 20]) resulting in the formation of a TiO2 layer, i.e., TiO x N y . It might be possible that during Ta2O5 deposition, Ti takes oxygen from Ta2O5, forms a TiO x N y layer, and makes a defective TaO x switching material. However, the TiO x N y layer will be more electrically ZD1839 solubility dmso conducting than the TaO x layer, and the conducting filament formation/rupture can happen inside the TaO x switching layer. Due to a series of TiO x N y layers with TaO x , enhanced resistive MK0683 price switching memory characteristics could be observed as discussed later. Figure 1 TEM images of the RRAM device. (a) A typical cross-sectional TEM image of a W/TaO x /TiN memory

device. The device size is 0.6 × 0.6 μm2. (b) A HRTEM image showing the stacking layer of TaO x and TiO x . Figure 2 exhibits self-compliance bipolar current-voltage (I-V) and corresponding resistance-voltage (R-V) characteristics of the W/TaO x /TiN RRAM devices. The voltage-sweeping directions are shown selleck chemical by arrows 1 to 4. The device sizes were 4 × 4 μm2 (Figure 2a) and 0.6 × 0.6 μm2 (Figure 2b). A small formation voltage (V form) of 1.3 V is needed to form the conducting filament, as shown in Figure 2a. After the first RESET operation, the memory devices show 100 consecutive switching cycles at a low self-compliance (SC) current of 139 to 196 μA with a small operation voltage of +1.5/−2 V for the 4-μm devices and 136 to 176 μA with an operation voltage of +2/−2.5 V for the 0.6-μm devices. The SET voltages are slightly varied from 1.0 to 1.2 V and 1.2 to 1.5 V for the 4- and 0.6-μm devices, respectively. Both high resistance state (HRS) and low resistance state (LRS) are varied with 100 cycles from 0.83 to 3.47 M and 28 to 55 kΩ, and 0.97 to 3.12 M and 37.4 to 64.7 kΩ at a read voltage (V read) of

0.1 V for the 4- and 0.6-μm devices, respectively. The RESET voltages and currents are found to be −1.45 V and approximately 165 μA, and −1.85 V and approximately 144 μA Decitabine for the 4- and 0.6-μm devices, respectively. In addition, non-linearity of the I-V curves at LRS for the 0.6-μm devices is better than that for the 4-μm devices (Figure 3). The 0.6-μm devices show higher values of SET/RESET voltages, better switching uniformity in cycles-to-cycles, better non-linearity, and lower SC operation, owing to the higher series resistivity to W TE than that of the 4-μm devices. However, all sizes of RRAM devices are operated with a small voltage of ±2.5 V. Figure 2 Current-voltage and resistance-voltage switching characteristics with different device sizes.