Moreover,

the direct flow of electrons contributes to the maximum photocurrent generation because of the large interfacial surface area [9]. In contrast to GaN, ZnO has a maximum electron saturation velocity; thus, photodetectors equipped with ZnO can perform at a maximum operation speed [10]. Different types of photosensors, such as p-n junction, metal–semiconductor-metal, and Schottky diodes, have been fabricated. However, metal–semiconductor-metal photosensors are becoming popular because of their simple structure [11]. The sensor photoconductivity AR-13324 purchase of ZnO depends on the growth condition, the surface morphology, and crystal quality [12]. The synthesis of ZnO nanostructures has been reported; however, the area-selective deposition of ZnO nanostructures or their integration into complex architectures (microgap electrode) is rarely reported [13–24]. In this manuscript, we report the deposition of ZnO nanorods on a selective area of microgap electrodes through simple low-cost, highly reproducible hydrothermal technique, and their applications in UV sensors were investigated. Methods Materials and method The UV sensor was fabricated with Schottky contacts by conventional photolithography followed by wet etching technique. ZnO nanorods were grown on the electrode

by hydrothermal process. The p-type (100) silicon substrate 3-oxoacyl-(acyl-carrier-protein) reductase was cleaned with RCA1 and RCA2 [25] to remove the contaminants. The find more RCA1 solution was prepared by mixing DI water, ammonium hydroxide (NH4OH

(27%)), and hydrogen peroxide (H2O2 (30%)) by maintaining the ratio of 5:1:1. For the RCA2 preparation, hydrochloric acid (HCL (27%)) and H2O2 (30%) were mixed in DI water by maintaining the composition at 6:1:1. An oxide layer with a thickness of approximately 1 μm was then deposited by wet oxidation process. Thin layers of titanium (Ti) (30 nm) and gold (Au) (150 nm) were deposited using a thermal AG-881 ic50 evaporator. As shown in Figure 1b, a zero-gap chrome mask was used in the butterfly topology. After UV exposure, controlled resist development process was performed to obtain a 6-μm gap. The seed solution was prepared as described in our previous research [25]. The concentration of zinc acetate dehydrate was 0.35 M in 2-methoxyethanol. Monoethanolamine (MEA) was added dropwise to the seed solution, which was heated to 60°C with vigorous stirring until the molar ratio of MEA to zinc acetate dehydrate reached 1:1. The seed solution was incubated at 60°C for 2 h with continuous stirring. The measured pH value for the MEA-based seed solution was 7.69. The aged solution was dropped onto the surface of the microgap structure, which was rotated at 3,000 rpm for 45 s.