However, the carbon black in air showed drastic weight loss starting at check details approximately 350°C, possibly due to combustion. No noticeable decrease in weight is observed in the argon atmosphere sample until approximately 650°C. To avoid degradation, an argon atmosphere was used and the temperature of calcination was set at 500°C to remove all residues in the https://www.selleckchem.com/products/pci-32765.html carbon black and improve the contact of TiO2. Figure 2 TGA in air and argon with the carbon black at a heating rate of 10°C/min. The ratios of T/CB slurry were varied from 10:1, 5:1, and 2.5:1 and 1:1 weight ratio for the counter electrode. J-V curves

for each ratio of T/CB slurry are shown in Figure 3, and the performance of these cells is listed in Table 1. The reference Pt cell shows 7.7% efficiency (η) with a 69.3% fill factor (FF), and the 5:1 ratio sample shows similar efficiency (7.4%) with a comparable FF (67.4%) and short-circuit current (J sc) (15.5 mA/cm2). Other samples show similar open-circuit potential (V oc) and FF, but the J sc are much lower than the Pt or 5:1 ratio cases. When the amount of carbon black is low (10:1 ratio), the adhesion of T/CB slurry to the FTO is better. However, reduction of I3 − is not active due to the low surface area available for triiodide reduction and it shows slightly lower J sc than the

5:1 ratio sample. A large amount of carbon black (2.5:1, 1:1 ratios) has enough surface area of reduction, but the poor adhesion of FTO CH5183284 and carbon black Selleck 5-Fluoracil makes it difficult to get high efficiency [15, 27, 29]. Figure 3 Photocurrent-voltage

curves of the devices. Table 1 Photovoltaic performance of Pt and TiO 2 /carbon black composites as counter electrode Composite J sc(mA/cm2) V oc(V) FF (%) η (%) Pt 15.5 0.73 69.3 7.7 T/CB (10:1) 14.1 0.71 64.6 6.6 T/CB (5:1) 15.5 0.71 67.4 7.4 T/CB (2.5:1) 13.5 0.69 68.7 6.5 T/CB (1:1) 12.6 0.66 61.3 5.1 Electrochemical impedance spectroscopies (EIS) of a dummy cell were analyzed to determine the interfacial electrochemical properties with ratios of T/CB. Figure 4 shows the Nyquist plots of symmetric cells with T/CB slurry ratios of 10:1, 5:1, 2.5:1, and 1:1 and a conventional Pt-coated counter electrode. The first arc of the Pt-based counter electrodes appears at 100,000 to approximately 100 Hz with only one spectrum of Pt electrode/electrolyte interface. Under 100 Hz, Warburg was obtained by electrolyte diffusion in the dummy cell. For the T/CB counter electrodes, impedance spectra exhibit three separated semicircles, which correspond to resistances at the counter electrode/electrolyte interface R ct, the TiO2/carbon black interface, and the electrolyte diffusion Zw [30]. The R ct value is directly related to the amount of carbon content in turn of the number of catalytic sites.