All cores were split lengthwise and visually described for color,

All cores were split lengthwise and visually described for color, composition, sedimentary structures and grain size. Sediment components were further analyzed with a binocular microscope and an Environmental Scanning Electron

Microscope (ESEM) equipped with Energy Dispersive Analysis X-ray (EDAX). All mTOR inhibitor cores were subsampled (2-cm interval) and measured for wet and dry bulk density as well as water and organic content following the loss-on-ignition method of Dean (1974). Following the sieve and pipette methods of Folk (1980), grain-size was measured on 15 samples of representative lithologies. Trace metal analysis of core C4 was made following the total digestion methods of Lacey et al. (2001) and Mecray et al. (2001). Pb, Cu, Cr, and Zn were measured on a Perkin-Elmer 7000 Atomic Absorption Spectrophotometer

(AAS) having a detection limit of 0.1 mg L−1. Measurement of the National Institute of Standards and Technology Buffalo River Sediment Reference Material yielded recoveries of between 90 and 101% of the reported values, indicating an efficient digestion process. Acid blank samples were below the detection limit of the AAS, indicating no contamination occurred during the digestion procedure. Four replicate samples reveal that variability within each sample was much less than downcore variability. In order to interpret the impoundment sediment in a historical context, core C4 was radiometrically dated. Core C4 recovered an undisturbed sediment surface and extended through the impoundment sediment to bedrock in the wide, deep downstream end of the dam pool (Fig. 2). TSA HDAC No obvious erosional boundaries were observed in core C4. The excess 210Pb that is not produced

by in situ radioactive decay can often be used to date sediment deposits spanning the last Leukocyte receptor tyrosine kinase 150 years (Appleby, 2001). To determine the 210Pb profile, 21 subsamples from core C4 were sent to MyCore Scientific Inc., Ontario, Canada where the alpha radiation of the granddaughter 210Po was measured using alpha spectrometry. An age interpretation of the 210Pb profile was made by using the constant rate of supply model. In order to delineate the impoundment sediment fill, historic and modern maps were analyzed. Full details of how the maps were georeferenced and analyzed are provided in Mann (2012). After georeferencing, the 1906 topographic map (Wilson et al., 1906) still displayed significant mismatches in parts of the gorge study area. Therefore, we only use the 1906 map to obtain an average channel slope of 0.014 m m−1 within the gorge prior to dam construction. The 22 bathymetric cross sections of Cook (1918) were used to delineate the impoundment sediment surface present in September 1918 (Fig. 2). After georeferencing, the 1918 bathymetric cross sections were digitized. The latitude, longitude and water depth were determined every 3.05 m (10 ft) along the cross sections. It was possible to read water depth to the nearest 15 cm (i.e., half foot).

Leave a Reply

Your email address will not be published. Required fields are marked *

*

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>